Stainless Steel Mist Nozzles 10/24 Thread 0.006 Orifice - 1000 to 1500 PSI - High pressure
0.006 Inch - High Pressure
Stainless Steel construction - corrosion resistant
10/24 Thread Size
Recommended Pressure: For high pressure misting systems (1000 -1500 PSI)
Full cone pattern spray 60-70 degrees
0.012 GPM (Gallons Per Minute) at 1000 PSI
- 0.006 Inch - High Pressure
- Stainless Steel construction - corrosion resistant
- 10/24 Thread Size
- Recommended Pressure: For high pressure misting systems (1000 -1500 PSI)
- Full cone pattern spray 60-70 degrees
- 0.012 GPM (Gallons Per Minute) at 1000 PSI
It works with most 1/4" OD flexible tubing.
Depending on the Misting Pump size; Mid or High pressure. These would work for a softening system.
Mid Pressure: Calcium Inhibitor Filter - Poly Phosphate Filter: Link: https://mistcooling.com/misting-calcium-inhibitor-filter-poly-phosphate-filter.html
High Pressure: 5in Commercial Filter. Link: https://mistcooling.com/commercial-filter-for-mist-pumps.html
Any large than the filters mentioned would be recommended for Hard Water.
The cartridge inside the housing should be changed every 6 months
If you are on the website scowl down to Description or Specifications.
Filter housings are rated for up to 125psi.
5 microns. You don't need to worry much about the GPM as this is used before the pump. You just want to make sure that the filter is changed every six months so that the unit doesn't struggle to get water through to the pump.